1991 Buick Roadmaster Remote

Important:Please make sure that your smart key fob looks identical and matches any of the part numbers or FCC IDs listed below. Contact Us with your VIN if you don’t have an existing remote for comparison.

Part Numbers: 88959920, 10205241, 10205239, 10205240, 12522338, 10063533, 10205239, 12522337, 12522339, 12522356, 10097895, 10097894, 10205674, 10092854, 10097894, 10063534, and 10178738

FCC ID: ABO0103T, GQ43VT1, ABO0104T, and ABO0116T

Buttons: Lock, Unlock, and Trunk

Frequency: 315 Mhz

Remote Programming:

Battery: CR2032 (included)

1. Locate the programming connector in the driver’s side of the trunk. It is a plastic connector with two wires leading up to it. It is not plugged into anything. You may have to pull back the trim to access the connector.
2. The programming connector should have 2 terminals. Connect both terminals with a suitable jumper wire. The locks will cycle to confirm entering programming mode. Make sure the terminals remain connected throughout the procedure.
3. Press any button on the remote once. Door locks will cycle to confirm.
4. If a second remote is to be programmed press any button on that remote. Door locks will cycle to confirm.
5. Remove the jumper wire from the programming connector.