1996 Hyundai Accent Dealer Installed Clifford Remote FCC: CZ57RRTX31 PN: 00243-16110

Important:Please make sure that your smart key fob looks identical and matches any of the part numbers or FCC IDs listed below. Contact Us with your VIN if you don’t have an existing remote for comparison.

Part Numbers: 00243-16110

FCC ID: CZ57RRTX3

Buttons: Lock and Unlock

Frequency: 302 MHz

Remote Programming: Onboard

Battery: CR2032 (included)

1. Locate the keyless entry control module just above the fuse panel underneath the driver’s side dash. Locate the black and white wires coming out of the control module. The black and white wires are typically found disconnected. In some cases the black and white wires lead to a valet switch.
2. Turn the ignition on and touch the black wire to the white wire 13 times (or flick the valet switch, if installed, 13 times.)
3. Press button 1 on the remote.
4. Turn off the ignition. Press button 1 on the remote. If the doors automatically lock then unlock continue to the next step, if not, repeat steps 2 and 3.
5. Turn on the ignition and touch the black wire to the white wire 14 times (or flick the valet switch, if installed, 14 times.)
6. Press button 2 on the remote.
7. Turn the ignition off. Press button 1. The driver door should unlock (if locked, press button 1 again to unlock.) Then press button 2. All the doors should unlock. If not, repeat steps 5 and 6.
8. Remove the programming switch and leave the white and black wires disconnected.