2010 Chrysler Sebring Remote Head Key FCC ID: OHT692427AA PN: 68273343AB

Remote For Chrysler:

This remote features 4 buttons: Lock, Unlock, Trunk and Panic. This remote sends it’s signals on a frequency of 315Mhz. This remote will work for your vehicle if your vehicle is equipped with factory keyless entry.

FCC ID: OHT692427AA

Part Number: 68273343AB, 5175815AA, 5175815AB, 68092982AA, 68092982AB, 68273343AA

Condition: Refurbished Chrysler

Programming Procedure:

Make sure you have two keys that will start the vehicle before beginning the procedure.

1. Cut the new key to match your existing keys.
2. Insert the first valid key into the ignition and turn the ignition on for more than 3 seconds but less than 15 seconds. Turn the ignition off and remove the first key.
3. Within 15 seconds, use the second valid key to turn the ignition to on. After 10 seconds a chime will sound and the theft alarm light will begin to flash. Turn the ignition to off and remove the second key.
4. Insert the newly cut invalid key into the ignition and turn the ignition to on within 60 seconds. After 10 seconds a single chime will sound. The theft alarm light will stop flashing, then it will turn on for 3 seconds; then it will turn off. The new key has been validated and will be able to start the vehicle. If it was a remote head key then the remote will now operate the keyless entry system. Repeat this procedure for up to 8 keys.

The following vehicles can use this remote when equipped with the factory keyless entry system:

2006 Chrysler PT Cruiser, 2007 Chrysler PT Cruiser, 2008 Chrysler PT Cruiser, 2009 Chrysler PT Cruiser, 2010 Chrysler PT Cruiser, 2007 Chrysler Sebring, 2008 Chrysler Sebring, 2009 Chrysler Sebring, 2010 Chrysler Sebring.