2011 Chrysler 200 Remote Head Key PN: 68291090AB

FCC ID: OHT692427AA

Part Number: 68291090AB

Replaces Part Numbers: 68025034AA, 68025034AB, 68092992AA, 68092992AB, 68291090AA

Brand: Chrysler

Condition: OEM New

This remote features 5 buttons: Lock, Unlock, Convertible Top, Trunk, Panic. This remote sends it’s signals on a frequency of 315 Mhz. This remote will work for your vehicle if your vehicle is equipped with factory smart keyless entry.

Programming Procedure:

On board programmable only if you have 2 working remote head keys available.

Use the following instructions to program an additional remote head keys:

1. Cut the additional Sentry Key Transponder blank(s) to match the ignition switch lock cylinder key code.

2. Insert the first valid key into the ignition switch and turn the ignition switch ON for at least 3 seconds but no longer than 15 seconds. Turn the ignition switch OFF and remove the first key.

3. Insert the second valid key and turn the ignition switch ON within 15 seconds. After ten seconds, a chime will sound and the Theft Alarm Light will begin to flash.Turn the ignition switch OFF and remove the second key.

4. Insert a blank Sentry Key into the ignition switch and turn the ignition switch ON within 60 seconds. After 10 seconds a single chime will sound. The Theft Alarm Light will stop flashing, turn on for 3 seconds; then turn off. The new Sentry Key has been programmed.

Repeat this procedure to program up to 8 keys.

Important: If you don’t have two working existing remote head keys you will need a dealer or automotive locksmith to program the vehicle to accept the replacement remote head keyand to cut a key. Please use an automotive locksmith rather than the dealer. You are likely to get a better service for a more reasonable price.

Locksmiths make their prices based on their local market as well as the cost of the equipment used for you cutting or programming. Locksmith equipment for key cutting and vehicle programming is very expensive and most of the charge is to compensate them for their initial equipment investment.
An automotive locksmith will program your new remotes or keys by hooking up an expensive scan tool to your vehicle computer and making the vehicle learn the new remotes or keys.

The following vehicles can use this remote when equipped with the factory keyless entry system:
Chrysler Sebring (2007-2010)
Chrysler 200 (2011-2014)